Discipline: Engineering - Electronic Engineering

 Complete the problems in the attachment and show steps.  Show all steps leading to the final answer. 

  Discuss your approach for finding the current, I, shown in the circuit below using Mesh Current Analysis. Give examples of dependent sources. What VCCS and CCCS stand for dependent sources?

 Explain Mechanical Sequencers. How are they implemented in the PLC? What  are the different types of PLC Sequencer Instructions available in  Studio 5000? Explain real-world examples for which Sequencer Ladder  Logic might be employed. 

   Determine by measurement the Norton Equivalent for the circuit between node A and Ground in Multisim. Show the calculations verifying the measurements taken to find the Norton Equivalent Circuit between node A and Ground.

  Is Thevenin’s theorem applicable to both AC and DC circuits? In your opinion, when finding the Thevenin equivalent as seen by  the load for the below circuit, would it be easier to use source  transformation or Superposition? Provide both solutions and explain your  approach.

 Explain three different Math Functions provided in the PLC controller inside, Studio 5000.  

   DETERMINE THE SUPERPOSITION CURRENTS AND TOTAL CURRENT THROUGH R2. DETERMINE THE SUPERPOSITION CURRENTS AND TOTAL CURRENT THROUGH R2 IF THE POLARITY OF VS2 IS REVERSED. Your step by step calculations of the currents using Superposition

You have explored the architecture of Allen Bradley PLCs and the core instructions that these PLCs have including the basic relay instructions, latch and unlatch instructions, one shots, timers, and counters. In this discussion, you will focus on timers how Allen Bradley PLCs and Siemens PLCs use timer instructions and the ample differences in these […]

  What is meant by Linearity when applying the superposition theorem? What is meant by a bilateral network? In your opinion, would solving the below circuit for V0 be easier using source transformation or Superposition? Provide both solutions and explain your approach.

   It has been proposed that a standard, equal leg structural steel angle be used for this application using ASTM A36 structural steel. Using the AISC (American Institute of Steel Construction) code, specify a suitable angle from Appendix A-5 shown. Following steps may be useful in fulfilling this task. Step1. Determine the yield strength sy […]